Skip to main content ↑ ↓
Topic: Mustang springs.... (Read 3062 times) previous topic - next topic

Mustang springs....

Will Mustang GT front springs be a direct swap in an '88 Sport?
'88 Sport--T-5,MGW shifter,Trick Flow R intake,Ed Curtis cam,Trick Flow heads,Scorpion rockers,75mm Accufab t-body,3G,mini starter,Taurus fan,BBK long tube headers,O/R H-Pipe, Flowamaster Super 44's, deep and deeper Cobra R wheels, Mass Air and 24's,8.8 with 3.73's,140 mph speedo,Mach 1 chin spoiler,SN-95 springs,CHE control arms,aluminum drive shaft and a lot more..

Mustang springs....

Reply #1 –
I put mustang GT springs from a 88 into my 87 Thunderbird TC with no problems. Lowered the car slightly too.
1988 Thunderbird Sport. Work in Progress
5.8L swap w/fitech efi, 4R70W swap w/quick 4 controller, 2003 GT rear diff, 5 Lug swap

Bought this car back as an old project car.

:burnout:

Mustang springs....

Reply #2 –
Thanks a lot.
'88 Sport--T-5,MGW shifter,Trick Flow R intake,Ed Curtis cam,Trick Flow heads,Scorpion rockers,75mm Accufab t-body,3G,mini starter,Taurus fan,BBK long tube headers,O/R H-Pipe, Flowamaster Super 44's, deep and deeper Cobra R wheels, Mass Air and 24's,8.8 with 3.73's,140 mph speedo,Mach 1 chin spoiler,SN-95 springs,CHE control arms,aluminum drive shaft and a lot more..

Mustang springs....

Reply #3 –
check the tech section on the main page for interchangeability. Shocks and struts are a no go, springs I think are OK

Mustang springs....

Reply #4 –
Springs aare all I need for now.
'88 Sport--T-5,MGW shifter,Trick Flow R intake,Ed Curtis cam,Trick Flow heads,Scorpion rockers,75mm Accufab t-body,3G,mini starter,Taurus fan,BBK long tube headers,O/R H-Pipe, Flowamaster Super 44's, deep and deeper Cobra R wheels, Mass Air and 24's,8.8 with 3.73's,140 mph speedo,Mach 1 chin spoiler,SN-95 springs,CHE control arms,aluminum drive shaft and a lot more..

Mustang springs....

Reply #5 –
You can use later Mustang ones in the front. I have stock 95's, with about a coil (and 1/8?) removed. Hard to remember how much, it's been 8 years.
Death awaits you all with nasty, big, pointy teeth.

1988 5.0 Bird, mostly stock, partly not, now gone to T-Bird heaven.
1990 Volvo 740GL. 114 tire-shredding horsies, baby!

Mustang springs....

Reply #6 –
The ones I want are for a Fox Stang with a one inch drop.
'88 Sport--T-5,MGW shifter,Trick Flow R intake,Ed Curtis cam,Trick Flow heads,Scorpion rockers,75mm Accufab t-body,3G,mini starter,Taurus fan,BBK long tube headers,O/R H-Pipe, Flowamaster Super 44's, deep and deeper Cobra R wheels, Mass Air and 24's,8.8 with 3.73's,140 mph speedo,Mach 1 chin spoiler,SN-95 springs,CHE control arms,aluminum drive shaft and a lot more..

Mustang springs....

Reply #7 –
Well, since Foxtang springs are apparently already shorter than our stockers, a lowering spring would likely have a Birdy sing its beak on the pavement.
Death awaits you all with nasty, big, pointy teeth.

1988 5.0 Bird, mostly stock, partly not, now gone to T-Bird heaven.
1990 Volvo 740GL. 114 tire-shredding horsies, baby!

Mustang springs....

Reply #8 –
Hmmmmmmmm,I didn't realize that.I wonder how low stok Stang springs would lower my Sport.I only want about an inch.
'88 Sport--T-5,MGW shifter,Trick Flow R intake,Ed Curtis cam,Trick Flow heads,Scorpion rockers,75mm Accufab t-body,3G,mini starter,Taurus fan,BBK long tube headers,O/R H-Pipe, Flowamaster Super 44's, deep and deeper Cobra R wheels, Mass Air and 24's,8.8 with 3.73's,140 mph speedo,Mach 1 chin spoiler,SN-95 springs,CHE control arms,aluminum drive shaft and a lot more..

Mustang springs....

Reply #9 –
I have cut (1 coil?) 4 cyl Mustang springs in the front of my TC.  Sits nice with 25" skinnies.
 

Mustang springs....

Reply #10 –
I don't want to cut any springs.I have fairly wide tires as well.
'88 Sport--T-5,MGW shifter,Trick Flow R intake,Ed Curtis cam,Trick Flow heads,Scorpion rockers,75mm Accufab t-body,3G,mini starter,Taurus fan,BBK long tube headers,O/R H-Pipe, Flowamaster Super 44's, deep and deeper Cobra R wheels, Mass Air and 24's,8.8 with 3.73's,140 mph speedo,Mach 1 chin spoiler,SN-95 springs,CHE control arms,aluminum drive shaft and a lot more..

Mustang springs....

Reply #11 –
Quote from: MasterBlaster;156546
Well, since Foxtang springs are apparently already shorter than our stockers, a lowering spring would likely have a Birdy sing its beak on the pavement.


No, no...they'll be fine.

This is how mine sits with BBK '87-93 Mustang 5.0 lowering coils in front. Actual drop, I dunno, I assume it to be about 1.5". It sits at almost the exact same height as the stockers did with about a coil and a half cut off (if I remember correctly)

Garrett H.
'94 F250 XLT- 4x4, 5 speed, 7.3 IDI Turbo Diesel, 4" intake, 4" exhaust, 5" turnout stacks, manual hubs, etc.
'87 Thunderbird Turbo Coupe
Engine, wheels, tires, etc!
Exhaust sound clip
Another clip

Mustang springs....

Reply #12 –
I tried stang (H&R 1-1/2") lowering springs in the rear of my 86' T/C and the bump stopshiznits before the springs did. I could still wiggle the springs freely but couldn't pull them out. Then I changed the rear suspension anway.


86' T/C 4.6L DOHC
16' Chebby Cruze 1.4L Turbo
17’ Peterbilt 389 600hp 1850ftlb Trq 18spd

[SIGPIC][/SIGPIC]

“Heavy Metal Mistress”
[/COLOR][/SIZE]

Mustang springs....

Reply #13 –
My rear suspension sits right,it's the front I want to drop just a little bit.
'88 Sport--T-5,MGW shifter,Trick Flow R intake,Ed Curtis cam,Trick Flow heads,Scorpion rockers,75mm Accufab t-body,3G,mini starter,Taurus fan,BBK long tube headers,O/R H-Pipe, Flowamaster Super 44's, deep and deeper Cobra R wheels, Mass Air and 24's,8.8 with 3.73's,140 mph speedo,Mach 1 chin spoiler,SN-95 springs,CHE control arms,aluminum drive shaft and a lot more..

Mustang springs....

Reply #14 –
http://www.partsamerica.com/ProductList.aspx?parttype=59&ptset=A&searchfor=Coil+Spring%2c+Front
 
Hey Vinnie you can compare them here.I used the cs8602 they dropped me an inch rides great,took a couple of weeks though to settle to that.the cs8658 are stock ones.
Old Grey Cat to this.88 Cat, 5.0 HO, CW mounts, mass air, CI custom cam, afr165's, Tmoss worked cobra intake, BBK shorty's,off road h pipe, magnaflow ex. T-5,spec stage 2 clutch, 8.8 373 TC trac loc, che ajustables with bullits on the rear. 11" brakes up front. +