K-member test fit July 21, 2006, 09:37:28 PM im sure this wont be new to most of you, it has been discussed to death. i didnt get anywhere on the IRS today, and i borrowed a engine hoist(thanks Chuck!) so this is what i did instead. pulled the engine/trans and stock Kmember. then test fit my new tubular unit:you hafta excuse my dirty engine bay. i jus got everything outta there and couldnt resist the oppurtunity to test fit new parts:D it will be cleaned before everything goes together officially. Quote Selected
K-member test fit Reply #1 – July 21, 2006, 09:59:20 PM Looks like a spacer between the K-member and the frame and you'll be set. Quote Selected
K-member test fit Reply #2 – July 21, 2006, 10:01:06 PM Looks great. Keep up the good work Quote Selected
K-member test fit Reply #3 – July 21, 2006, 10:10:38 PM spacer and a small amount of grindin on the outboard hole in each rear position. not bad, nuthin unexpected. Quote Selected
K-member test fit Reply #4 – July 21, 2006, 10:24:49 PM Go! Go! Anti-dive!Oh, wait.....I did that :pIs the IRS modded? I don't remember. I'll be surprised if you have any dive in that thing under braking. I know on my car it is very minimal. Quote Selected
K-member test fit Reply #5 – July 21, 2006, 11:13:37 PM go go anti-dive is right :D you had a hand in that too, eh?yes the IRS is a modded version. im hoping for very little dive in the end Quote Selected
K-member test fit Reply #6 – July 21, 2006, 11:18:59 PM Quote from: gumbygo go anti-dive is right :D you had a hand in that too, eh?Who do you think gave the manf guys the new location points? ;) Quote Selected
K-member test fit Reply #7 – July 21, 2006, 11:20:55 PM hahaha, what about the IRS geometry, whos the responsible party there??i have good understandin of how the geometry works, but only a mild knowledge about what to move where to get exactly the result your lookin for. i jus make the stuff fit the cars, lol. Quote Selected
K-member test fit Reply #8 – July 21, 2006, 11:33:19 PM I worked alot on the IRS as well...there was alot of back and forth on that. I think we did the best we could with what we had to work with though.I remember when we did one of the first ones...but hadn't changed the subframe mounting bushings yet....uh, yeah..that was scary..... Quote Selected
K-member test fit Reply #9 – July 22, 2006, 08:37:29 AM yeah, i know there are compromises in it to keep it within packagin limitations. i figured you would have been in on that as well, even though no one ever mentioned you:flip: kermit is/was still like that. all modded w/tubular arms and coilovers with stock rubber mountin bushings... Quote Selected
Topic: K-member test fit (Read 1631 times)
previous topic - next topic
