The time has come...

Topic: The time has come... (Read 1356 times) previous topic - next topic

The time has come...

September 02, 2014, 08:50:11 PM

I'm selling my '88 Thunderbird Sport. I got in over my head and can't finish the engine swap (tried to go 351W). Here's the details:

1988 Thunderbird Sport
150K on the chassis
Medium Red exterior
Scarlet Red interior (rear seat is faded)
Power windows
Power driver seat
Power mirrors
AOD transmission
Some rust behind the driver side door
Damage behind the passenger side door (have replacement door, included)
Crack on front fender
Fading paint on hood and top
Aftermarket chrome wheels

Rebuilt 351W engine from a F150
Attempted to go Carberator with this kit: http://www.summitracing.com/parts/cmb-03-0214
Has this Distributor kit: http://www.summitracing.com/parts/pnx-combo351wr
Lokar kick down bracket
Ran new fuel line (soft line)
Holley Blue pump, pre and post filter
Interstate battery
Chuck W motor mounts
Monroe Variable rate springs (installed on rear, have front set)
Electronic fan with temp controller
New dual exhaust with H pipe
New lers (Mangaflow, I think, I can check)
Ford Racing valve covers

This car does not currently run. It ran 2 years ago with the EFI setup (very, very rough) and I couldn't get that sorted out, so I tried to go carb. It will need to be taken out on a trailer. I will help load it. I have more pictures and can get more, but it may take a couple days as the car isn't at my house (parents).

Asking price is $1400 or best offer. I'm not willing to part out the car yet, I would like to get rid of it outright. Location is 30 minutes west of St Louis down I-44. Contact me through email or PM.

The time has come...

Reply #1 – September 14, 2014, 04:21:58 PM

BTT. Dropped price to $1400.

The time has come...

Reply #2 – September 14, 2014, 05:03:49 PM

to bad your so far away

The time has come...

Reply #3 – October 08, 2014, 07:56:25 PM

Btt.

The time has come...

Reply #4 – October 09, 2014, 07:38:35 AM

If you were closer, I'd drive out and get it today....... .

The time has come...

Reply #5 – October 09, 2014, 02:13:44 PM

Is it a 351 roller block?

The time has come...

Reply #6 – October 10, 2014, 04:26:49 AM

Man, get ya a duraspark ignition from the autozone and drive it, I think a brown connector is the ford truck motor connector. Looks super nice! That lokar kit should be enough to get the tires to spin, top notch parts..