Skip to main content ↑ ↓
Topic: Alternator wiring (Read 1031 times) previous topic - next topic

Alternator wiring

Quick question I can't seem to get a stwaight answer on. No both of the orang /black wires run into eachother on the alternator harness. I need to replace a harness and one wire either fell out or was pulled out of the connector and just taped up. And the new pigtail had 3 wires. Don't wsnt to fry anything. Any input would be great

Alternator wiring

Reply #1 –
Yes the two BK/O wires are tied together. They use two wires at the connector to split the current load between two connectors terminals.
This prevents the connector from overheating.
The third wire W/BK goes to the "S" terminal on the regulator.

Alternator wiring

Reply #2 –
I posted the stock 2G alternator that was original equipment for the 88 5.0.
If it doesn't match what you have, the alternator has been upgraded to a newer alternator.
If so give us a pic and or describe what you have.

Alternator wiring

Reply #3 –
Was this car originally a 2.3L Turbo Coupe? If so, they used a different alternator.

Alternator wiring

Reply #4 –
Quote from: softtouch;433653
They use two wires at the connector to split the current load between two connectors terminals.
This prevents the connector from overheating.

Would explain why the old pigtail is like half melted and soft to the touch.
 

Alternator wiring

Reply #6 –
and a sticky dedicated to it ,,
beware if your moding a previously 2.3L engine... these are in my diy link below... or check out the 3g sticky drawings of the illustrated before  / after