Skip to main content ↑ ↓
Topic: Chassis Part Needed (Read 656 times) previous topic - next topic

Chassis Part Needed

I am looking for some chassis parts for my Cougar.

Tubular K member
Control Arms
Camber Plates
Coil Over Kit
Manual Steering Rack and Pinion
Steering Sector Shaft

Someone here has one or all of these parts laying around so lets help a member complete a project.

Thanks everyone.
Doug
Blueprinted 306, Thumper ported Canfield 195's, TLSR Camshaft, custom motor mounts, Parker funnelweb, Pro Systems Carburetor, Tremec 3550 II, 4.30 gears, Moser Axles, Team Z custom suspension with upper relocation brackets and anti roll bar.  At the track I run M/T 26/10's on Weld Star rims.

Chassis Part Needed

Reply #1 –
I have the rag joint that goes between the rack and where it unbolts from the steering shaft.
Old Grey Cat to this.88 Cat, 5.0 HO, CW mounts, mass air, CI custom cam, afr165's, Tmoss worked cobra intake, BBK shorty's,off road h pipe, magnaflow ex. T-5,spec stage 2 clutch, 8.8 373 TC trac loc, che ajustables with bullits on the rear. 11" brakes up front. +

Chassis Part Needed

Reply #2 –
I found the manual rack at rock auto for just over $100.

Chassis Part Needed

Reply #3 –
What year is the cougar? I have an 87 thunderbird with the control arms still on it.