What Can I use in the 88TC from a 96 GT Stang

Topic: What Can I use in the 88TC from a 96 GT Stang (Read 968 times) previous topic - next topic

What Can I use in the 88TC from a 96 GT Stang

November 04, 2010, 08:06:52 PM

I have a line on an 96 mustang gt and would like to know If I can used the rearend and t5 in my TC Oh ya I would also be using the front spendals ?sp and roters for the 5 lug swap. should everything bolt in???

What Can I use in the 88TC from a 96 GT Stang

Reply #1 – November 04, 2010, 08:08:50 PM

Oh ya I currently have CHE upper and lower both adjustables with mach springs and strange 10way adjustables in the rear I also have the mach springs and strange adjustables in the front. But second gear is rappidly going out and I have a bad vibration comming from the rearend on the current set up.

What Can I use in the 88TC from a 96 GT Stang

Reply #2 – November 05, 2010, 12:08:30 AM

You can use the rear end for sure. The front spindles, 5 lug brakes will work also. You'll want to run the SN95 master cylinder for the best pedal effort/feel.

Unfortunately, the T5 won't work - as the input shaft is too long on the SN95 cars.

Everything else can be fabricated up. Even the interior could be swapped if you wanted.

Good luck!

What Can I use in the 88TC from a 96 GT Stang

Reply #3 – November 05, 2010, 01:48:47 AM

The '96 spindles are a big NO for your '88.

'94/'95 only on those..read THIS for the appropriate info and links to explain.

As mentioned above, the rear is a direct swap, or if it's the 7.5 (V6 car only) you can pull the axles, brakes, etc and swap onto your 8.8 .

Do grab the front rotors, calipers and struts if you can, then all you need is the '94-'95 spindles...good to go.