tach install

Topic: tach install (Read 1980 times) previous topic - next topic

tach install

April 20, 2005, 10:03:32 AM

I need help installing my autometer 5" tach. No memory or shift light. The only part I need help with is wiring up the dash light and the ignition. Please.

Re: tach install

Reply #1 – April 20, 2005, 10:14:38 AM

Dash light 12v+ is a light blue/red stripe wire. You can tap into that off the back of the clock or the radio. The ignition 12v+ should be white/purple stripe and you can also get that from the clock.

Re: tach install

Reply #2 – April 20, 2005, 08:25:12 PM

Welp I just hooked everything up and nothing. The light inside of it works fine but the tach doesn't read. It just stays at 0. I have the black wire grounded to the engine block. I'm thinking it's maybe the coil connection. Is there a certain way you're supposed to hook it up to the coil? I don't know. Maybe the tach is broken. Any help would be appreciated.

Re: tach install

Reply #3 – April 20, 2005, 10:07:04 PM

what engine do you have 4,6,8? I'm not sure about 4,6 but they should be the same , you need to connect the green wire of the tach to the side of the coil that recieves power upon ignition (when key is turned). Use a test light on either side of the coil to find out which wire is power (wire should be green also). Also if you have a 4 or 6 you have to cut one or two (depending on which 4,or 6) of the small wires coming out of the tach in the rear.
(should be orange and brown- refer to the instructions)

Re: tach install

Reply #4 – April 21, 2005, 10:54:21 AM

The engine is a 5.0. Now I'm confused on where my coil is. What I thought was it, my dad says its the a solenoid. Where is the coil located on these cars?

Re: tach install

Reply #5 – April 21, 2005, 11:23:00 AM

Ok nevermind. I found it. Works awsome. My idle is way too high though. Its sits at 2300 lol. My idle screw is all the way out. Must be my iac or i have a vacume leak. I also got my cam yesterday. Buying some gaskets and oil and hopefully stabbing it in tomorrow. Can't wait. I love it when stuff goes right.

Re: tach install

Reply #6 – April 21, 2005, 09:27:14 PM

check your tps also that can cause high idle.