Skip to main content ↑ ↓
Topic: new brakes (Read 1211 times) previous topic - next topic

new brakes

i got a few pictures of my old brakes compared to new brake setup.
84 el camino ss-daily driver(efi mild sbc,2004r, posi 3:42 rear.)
84 mercury cougar v6- was a v6/ nitrous drag car, going back to mostly stock
81 chevy malibu-protouring/  drag car.( efi sbc supercharged 283 that will rev to the moon, 2004r, 4:11 posi rear)

new brakes

Reply #1 –
What all did you do? I see the new rotor.

new brakes

Reply #2 –
new brake lines, new pads, rebuilt the calipers, drilled and slotted rotors and lakewood drag struts for the front.
84 el camino ss-daily driver(efi mild sbc,2004r, posi 3:42 rear.)
84 mercury cougar v6- was a v6/ nitrous drag car, going back to mostly stock
81 chevy malibu-protouring/  drag car.( efi sbc supercharged 283 that will rev to the moon, 2004r, 4:11 posi rear)
 

new brakes

Reply #3 –
Cool, I'm in need of brakes is why I asked. Being on a budget I am debating on what to do. I would like to go with the Mustang 4 lug set up, but that seems to be adding up to big bucks before I am done. I may just  go like you did and freshen mine up.

new brakes

Reply #4 –
the nice thing about the drilled and slotted are there the same size as stock 10 inch brake rotor but they are better than stock though.
84 el camino ss-daily driver(efi mild sbc,2004r, posi 3:42 rear.)
84 mercury cougar v6- was a v6/ nitrous drag car, going back to mostly stock
81 chevy malibu-protouring/  drag car.( efi sbc supercharged 283 that will rev to the moon, 2004r, 4:11 posi rear)

new brakes

Reply #5 –
Where did you get them??(rotors), $
88 sport,TW heads, comp xe270hr, cobra u/Tmoss ported lower, 65 mm throttle body, under drives,smog delete,
1.7 roller rockers, cai, k&n, bbk adj regulator, 76mm Pro-m,all MSD ign. MSD dist,18° base timing, 3g alt.1 5/8 ceramic headers, 255lph walbro, 2.5" h-pipe, flowmasters, silverfox valvebody, 3.73 gear,
http://i216.photobucket.com/albums/cc154/flipnbird/DSCF0185.jpg ( RIP : ( )

new brakes

Reply #6 –
Drilled/Slotted removes mass and surface area which is used to conduct heat. Vented discs help cool but drilled/slotted will do nothing but INCREASE your stopping distance. Read all you want from the sellers of these things but a standard flat/vented rotor will outperform drilled/slotted. Any low end drilled/slotted are also not cast that way - normal rotors are taken and machined - this goes against structural integrity. One should stick with decent replacement vented rotors if they want the best braking.

The only improvements you can make are tires, NEW brake hardware when it gets worn out, better proportioning, and larger rotors/pistons/number of pistons. Once your tires lock up (they should all be able to with enough force with the FACTORY brakes unless you auto cross), there is nothing the brakes can do further without additional grip to the pavement.
1988 Thunderbird Sport