Internal Engine Rust January 07, 2009, 09:28:54 AM Long story short:Due to uncontrollable cirspoogestances, The engine was apart longer than i wanted it to. And a few small rust spots accumulated just below the intake manifold, around the lifter housings where i had some shop towels covering and apparently got damp from moisture .It's just surface rust at this point, But im really unsure of what to do about it and kind of worried (i always get worried when rust is involved )I figure i should just try to disolve the rust and wire brush it.But should i do anything further? like sanding it back flush or putting some kind of protectant over it? and what? Quote Selected
Internal Engine Rust Reply #1 – January 07, 2009, 10:44:10 AM If you're gonna continue keeping it stored then I would spray it with engine fogging oil. Quote Selected
Internal Engine Rust Reply #2 – January 08, 2009, 07:57:19 AM I'll pick some of that up, Thanks.As for the rust~I found out autozone carries "Evapo-Rust".I've heard great things of this chemical, And think ill give it a try.Anyone used it before? How was the results? Quote Selected
Topic: Internal Engine Rust (Read 728 times)
previous topic - next topic
