few axle questions

Topic: few axle questions (Read 1143 times) previous topic - next topic

few axle questions

December 18, 2008, 02:11:08 PM

building the mustang strictly stock now *was a 4cyl car*, the axle swap for the cougar is done.
to swap a mustang 7.5 to 5 lug, what is needed? is it the same as the thundercats? I know the tbirds have a wider track. worse comes to worse i can switch complete rear axles from a 'bird. also is there a length difference in drive shafts from a 5spd to a aod on the stang?

few axle questions

Reply #1 – December 18, 2008, 03:59:12 PM

all 79-04 mustangs share the same length driveshaft that have solid axles. the difference is the trans yoke.

you would use driver side ranger/broncoII axles or passenger side from an aerostar.

few axle questions

Reply #2 – December 19, 2008, 08:20:05 AM

ok cool, so it's the same setup,someone told me different and i got confused...should always follow my own judgment:beatyoass:

few axle questions

Reply #3 – December 19, 2008, 10:32:35 AM

Quote from: 86Tbuzzard;248125

ok cool, so it's the same setup,someone told me different and i got confused...should always follow my own judgment:beatyoass:

Not sure what you mean by "the same set-up".

To keep the narrower Fox Mustang track, you need to use the axles mentioned. I'm pretty sure it's Ranger drums you need to use as well.

few axle questions

Reply #4 – December 19, 2008, 03:35:56 PM

same as in, far as axles and ranger rotors for a 5 lug, i got 2 ranger complete axles coming,for axle shafts, and gears