A pillar gauge pod?
Reply #26 –
The gauges are actually nice & close & easy to read up there! :D
Yeah, I cut down a full console to make a mini-console for the shifter & boot etc... I realized when I looked at the pic that the red just doesn't cut it - even though the car is red. I had one that was black & didn't quite look right as the top part is greyish. I would have kept it, but the seat malfunctioned and crushed the old mini-console - doh! I cut the console one plastic thickness behind the mounting tabs for the screws that hold the shifter boot bezel on. I cut a little plate and capped the end of the mini-console. It looks great - the end is mostly blocked by the mini-console.
And yes, that is the original consolete behind the mini-console - still attached to the seat :D
Oh, and the armrest uses the foam from the rear pimp-stick from a junk 20th I had. Because of the location of the shifter, I needed an arm-rest that was about an inch shorter - luckily the rear pad & leather fit pretty nicely!!
Oh, and the lighted LED switch on the bottom opening in the dash center is for the line-lock, there is one beside the antenna switch for the E-Locker rear. The LED bezels on the A-Pillar are superbright LED's triggered by an RPM switch (shift light) and one of the LED's in the bottom of the dash center is for the Water Injection & there is also a 4 position switch for the TwEECer hidden behind the cup-holder (to the right of the shifter handle.)
Oh, and hanging out of the glovvy is the cable for the LM-1. Velcro'd to the back of the glove box is the DataQ box.
Topic: A pillar gauge pod? (Read 8069 times)
previous topic - next topic
