rocker/ Vv pan clearance problems May 04, 2007, 08:41:11 PM I installed crane cam roller rockers (# crn-44746-16) and my stock valve pan covers are 1/2 inch to short, so its time to install a set of tall valve pan covers. I was thinking about getting the edelbrock aluminum covers(# edl-4261). Has anyone used this combo before. It would be good to know if it will work before I buy. If someone used another pan that worked with these rockers what is it? Quote Selected
rocker/ Vv pan clearance problems Reply #1 – May 04, 2007, 09:01:32 PM you could use stock 5.0 HO aluminum v/c. Quote Selected
rocker/ Vv pan clearance problems Reply #2 – May 06, 2007, 06:53:19 PM My heads are e7te and the steel covers they came with wont even come close to fitting. Are the 5.0 H.0 alum covers taller? Quote Selected
rocker/ Vv pan clearance problems Reply #3 – May 06, 2007, 07:54:07 PM the steel covers should clear the 1.7's the cast h.o covers will not thats why the 93 cobra had steel covers.the motorsport tall aluminum covers should clear fine. Quote Selected
rocker/ Vv pan clearance problems Reply #4 – May 06, 2007, 07:57:10 PM My stock HO rocker covers cleared my cobra 1.7s without removing the baffle.Used an ebay thick rubber/steel reinforced gasket though. Quote Selected
rocker/ Vv pan clearance problems Reply #5 – May 06, 2007, 08:29:58 PM Are the cobra 1.7 aluminum rockers only or are they a full roller rocker. the full rollers must be larger. I looked on the edelbrock web site and it says there short pans will clear aluminum rockers and there tall pans will clear roller rockers. Quote Selected
rocker/ Vv pan clearance problems Reply #6 – May 06, 2007, 11:30:06 PM Full roller aluminum Quote Selected
Topic: rocker/ Vv pan clearance problems (Read 1075 times)
previous topic - next topic
