ok one last time bbk

Topic: ok one last time bbk (Read 1017 times) previous topic - next topic

ok one last time bbk

April 01, 2006, 07:00:52 PM

ok just before i take the 400$ leap is there any issues with clearance or sensor placement on bbk shortie headers and aftermarket x pipe?
thanks alot

ok one last time bbk

Reply #1 – April 01, 2006, 09:11:35 PM

x-pipe? do you have a manual trans. i don't recall any x-pipes that will clear auto trans.

ok one last time bbk

Reply #2 – April 03, 2006, 03:45:26 PM

My BBK X-Pipe was too close to my AOD. The shift linkage wanted to turn right into it.

You could ding the out of the pipe and make it work, but I think I converted the shift linkage to the Mustang setup (It either rotated upward instead of downward, or it was just mounted much closer to the transmission body. I don't remember exactly, now). This was functional but really didn't work too well, and I changed to a T5 shortly thereafter. Sorry, my memory is fuzzy about it, but I can tell you that you will definitely have some clearance issues to work out.

--Ed

ok one last time bbk

Reply #3 – April 03, 2006, 08:57:32 PM

Ed's right, I tried a BBK X on my Bird and it was all over the stock shift linkage... Rather than hack it up I put my Hooker H pipe back on.

Here's three pipes for comparo... 1st is a LSC Lincoln, 2nd is my Hooker H and last is the BBK X... Note how the left pipe curves more inward than the others...

ok one last time bbk

Reply #4 – April 04, 2006, 10:54:07 PM

thanks guys