Skip to main content ↑ ↓
Topic: door handles?? (Read 3879 times) previous topic - next topic

Re: door handles??

Reply #15 –
Quote from: Paul Flockhart
Did you or someone else witness this?
If so,  you did not press charges and make him spend a little while in the pokey because......?


Happened to me in the winter of '98.  He paid for the handles (made him replace both) after a call from my lawyer.  He drove a Geo Tracker........I think that was punishment enough.  :grinno:

Re: door handles??

Reply #16 –
A Geo?Wow,that has to suck.....and hurt.
'88 Sport--T-5,MGW shifter,Trick Flow R intake,Ed Curtis cam,Trick Flow heads,Scorpion rockers,75mm Accufab t-body,3G,mini starter,Taurus fan,BBK long tube headers,O/R H-Pipe, Flowamaster Super 44's, deep and deeper Cobra R wheels, Mass Air and 24's,8.8 with 3.73's,140 mph speedo,Mach 1 chin spoiler,SN-95 springs,CHE control arms,aluminum drive shaft and a lot more..

Re: door handles??

Reply #17 –
ok, so i tried to take one of my handles out today, and i ran into a problem. I got to the two rivets and one of them were busted, can't seem to get it out. Is there any way i can get it out? should I just drill in a bigger hole or what?

Re: door handles??

Reply #18 –
Quote
He paid for the handles (made him replace both) after a call from my lawyer. He drove a Geo Tracker........I think that was punishment enough.


Time has been served indeed :rollin:
-- 05 Mustang GT-Whipplecharged !!
--87 5.0 Trick Flow Heads & Intake - Custom Cam - Many other goodies...3100Lbs...Low12's!

Re: door handles??

Reply #19 –
Quote from: 87tbird302
ok, so i tried to take one of my handles out today, and i ran into a problem. I got to the two rivets and one of them were busted, can't seem to get it out. Is there any way i can get it out? should I just drill in a bigger hole or what?



Just drill the holes slightly bigger than what they are now and then follow Eric's advice and use carriage bolts with thread locker.  You'll thank yourself and Eric later.