Skip to main content ↑ ↓
Topic: HELP!! firing order and placement. (Read 2615 times) previous topic - next topic

HELP!! firing order and placement.

1990 Mercury Cougar LS V6 3.8 (non superchanger)

 i just change the intion pole and cap, rotor, plugs, wire. put them back on and enginellike they were but the wouldn't kick over?  :mad:

 could some show a pick on how the plugs go on the cap and the placement of the intion pole??

lookd on goolge. but nothing  :bs:

 and i cheap way of fixing this too

Re: HELP!! firing order and placement.

Reply #1 –

whoops sorry if you saw the first one that was for a 2.8 v-6. This is the right one.
http://members.tripod.com/torquespecs/mustang_capri_1979-93_v6-3_8.htm
Quote from: jcassity
I honestly dont think you could exceed the cost of a new car buy installing new *stock* parts everywhere in your coug our tbird. Its just plain impossible. You could revamp the entire drivetrain/engine/suspenstion and still come out ahead.
Hooligans! 
1988 Crown Vic wagon. 120K California car. Wifes grocery getter. (junked)
1987 Ford Thunderbird LX. 5.0. s.o., sn-95 t-5 and an f-150 clutch. Driven daily and going strong.
1986 cougar.
lilsammywasapunkrocker@yahoo.com

Re: HELP!! firing order and placement.

Reply #2 –
spec's from mitchell repair....

passenger side front to back 1,2,3

driver side front to back  4,5,6

firing order is 1,4,2,5,3,6

and the number one plug wire on the distributor cap is the first one right of the front lock down tab..

oh and the firing order starts counter clockwise
Quote
there's only about a half a dozen man made objects that are herd by the human ear below 40Hz,a pipe organ,thunder,the space shuttle lifting off,a jet airplane taking off or landing,a large canon,an atomic bomb ignited in your back yard and the heat wave afterward oh wait you would be dead so you would'nt hear it scratch that!,and maybe beating your hear against a wall less then 40 times a second..rap music is'nt one of them!thats 40-60Hz@100+db the moving air is under 40Hz
 

Re: HELP!! firing order and placement.

Reply #3 –
THX Haystack that helpd alot. i markd were it come from and took pix of it. but it looked like the old way was out of time too(but it run, try to stall at lights tho).