p/s pressure line question February 07, 2010, 04:18:48 PM On the p/s pressure hose, is there supposed to be an o-ring on the fittings on both ends? I know it has one where the fitting goes into the pump, but on the other end, under the motor, it is g out power steering fluid. I took the hose out, and noticed there wasn't an o-ring on the bottomside fitting. Quote Selected
p/s pressure line question Reply #1 – February 07, 2010, 05:50:18 PM O-rings are a big 10-4. Quote Selected
p/s pressure line question Reply #2 – February 07, 2010, 05:52:45 PM make sure the o-ring is not stuck in the pump or possibly a second o-ring from the original hose if you just replaced it Quote Selected
p/s pressure line question Reply #3 – February 07, 2010, 06:14:07 PM The fitting on the pump side is fine, it's the fitting on the other end of the hose that threads in beneath the motor. I didn't replace the hose (yet), I just noticed that there wasn't an o-ring on the bottom end of the hose, and was wondering if there is supposed to be one. Quote Selected
p/s pressure line question Reply #4 – February 07, 2010, 06:14:33 PM Quote from: vinnietbird;309545O-rings are a big 10-4.Alrighty thanks vinnie. Quote Selected
Topic: p/s pressure line question (Read 1060 times)
previous topic - next topic
