Print Page - will these motor mounts work?

Title: will these motor mounts work?
Post by: 32VFoxBird on July 21, 2006, 10:46:07 PM

on an 88 302 t-bird?

http://cgi.ebay.com/ebaymotors/Set-Of-Ford-Motor-Mounts-Many-289-and-302-R-L_W0QQcmdZViewItemQQcategoryZ50454QQihZ014QQitemZ330009972847QQrdZ1

Title: will these motor mounts work?
Post by: Chuck W on July 21, 2006, 10:56:17 PM

Doubtful.

I'll be doing another small batch of mine in the near future if interest.

Title: will these motor mounts work?
Post by: Sick88Tbird on July 22, 2006, 06:39:10 AM

I think I've seen a set of them in MM&FF being used as motor mounts on a dyno...I thought the exact same thing...where did they get them and would they fit?...probably doesn't have the right offset though.

Title: will these motor mounts work?
Post by: 32VFoxBird on July 22, 2006, 09:23:14 AM

Quote from: Sick88Tbird

I think I've seen a set of them in MM&FF being used as motor mounts on a dyno...I thought the exact same thing...where did they get them and would they fit?...probably doesn't have the right offset though.

65-72 windsor mustang/fairlanes

Title: will these motor mounts work?
Post by: TurboCoupe50 on July 22, 2006, 10:57:33 AM

Those are made to fit a 45* mounting pad on the crossmember... '86-'88 Birds/Cougs use a setup with a flat pad.... No worky...

If you just need insulators, the ones '89-'90 3.8 MN12s are reported to fit... If you are looking for a strong, cheap replacement AFIK you are SOL...

Fox T-Bird/Cougar Forums

Technical => Engine Tech => Topic started by: 32VFoxBird on July 21, 2006, 10:46:07 PM