Folks-
I have one set of my motor mounts for the 5.0 Tbirds/Cougars unspoken for in this batch. They will be going to the platers this week, so depending on the turnaround from my poly supplier, they should be shipping in 3-4 weeks.
(http://www.turbochuck.com/images/Motor%20Mounts/Type%206/Type%206_1.jpg)
They are being offered with a choice of isolators. Either the std 70A durometer or a slightly softer 60A durometer.
Pricing is $135/set for the 70's and $140 for the 60's. I will ordering my poly based on the orders, so I need to wrap these up soon and get things ordered.
There will be more, just don't have a timeframe as of yet.
Chuck
cwarren@indy.net
Will those fit an AMC 401? :D:D:D
Well I went ahead and ordered the isolators for this set with the rest since no one spoke up.
This set will have the 70A isolators.
GIMME!
(translation: I'll take them, if they are still available. I've sent you a PM) :D
Looks like they have found a home.
Do you have anymore 5.0 mounts still avalible?
put me on the list too
If you guys are interested send me an email. I'll be doing more.
cwarren@indy.net
Chuck
Hmmm... have you had anyone install these on a 351w?
Well my concern was with the engine height. I'm not too familiar with 86-88 mounts but it looks like there is a way to modify them to "adjust" the height by removing some of the isolator?
But either way I want a set.
If you want a set email me ;) That is the only way I keep track of interest.
I could always adjust the height a touch when I build them but I wouldn't go any lower than an extra 1/2" w/o knowing exactly how much clearance you have over the K-member. I wouldn't take the height out of the isolator itself.
Ok, so....
I have a set of mounts available in the batch I will be shipping w/in the next week. They have the stiffer isolators.
The total would be $143/shipped.
Anyone interested? Email me.
Chuck
cwarren@indy.net