looking for a decent trottle body and spacer for a new 5.0 build i am doing.
something better than stock
i wont haggle, just gathering parts for this project.
better then stock as in h.o.? I have a throttle body and egr spacer of an h.o. motor.
well,, i think thats 55mm?
need to ask about the bore diameter on that PP intake im getting.
I have one from an explorer, 65mm.
professional products edelbroke rip off should be 70mm.
Pls sell if you can.....
i just noticed the explorer upper is kinda "knecked" inward but its actually 73mm just an inch up into the bore.
yeah,,, i hear ya!,,,good part is my cash is staying in the country.
even on masons build not a dime went to another countries stock exchange.
been wondering whats up with the PP intake tag saying made in USA.
are you interested? I have no need for it.
yep, sure am...
sad part is i tossed out a couple stock TB's,, totally forgot to save the shaft to transition it over... oh well
I'm sure someone here might have one! lol
I have a stock HO unit. No tps or iac. Cover the shipping and its yours
As a FYI: the opening on the stock Explorer GT40 upper is 68mm-70mm depending on how it was finished. I've measured 4 of them and one was 68mm, two were 69mm, and one was 70mm. All of them were off 96-97 Explorers. I have the one with a 70mm opening on my Thunderbird right now as I'm running a 70mm TB. You can open them up easy but since I had 4 laying around it was easier to just use the one with the correct opening.
check yours again,,
i was measureing about 1'' or so up inside the bore,, not the actual end of the bore.
i noticed the bore on the end where the spacer mounts kinda tapers inward a little.
thank you,, send me your addy on pm and i will get you a post office money order out monday.
Pm sent. Hopefully ya got it. My ucp isn't showing I sent it
good to go,
gotta get money orders out tomorrow myself.
I measured mine at the end of the bore. I wanted it to be the same size as the throttle body/EGR spacer. It may be bigger past the end of the bore. I do have another upper sitting in the garage I can measure. It does look slightly larger beyond the . The most important thing is that the end of the bore is the same size as the throttle body/EGR spacer and not smaller.
ttt
still need 65mm tb and spacer