Some things in life are more important than play toys, such as paying off my debt so I can buy a house for my family... So, I am now parting out my 88 Turbocoupe. If anyone has any parts interest, please reply to this or shoot me a PM. I will be updating this and listing the bigger/more commonly sold items over the next few days, but just trying to generate interest.
Headlights- SOLD!
Corner lights- SOLD!
Header panel- $75 as is, $125 if I sand, fill, and prime. has large paint chips but no cracks or anything that I see
PRC covers- $5 each
ABS pump- $150 Brakes worked perfectly fine on the 20 mile drive home, only time I ever drove the car
Hood with scoops and ducting- $75 as is, $15o if I sand, fill, and prime. has a small dent about dead center
Fuel Rail with AFPR- $50
LA3- $50 has a hole cut in one end, looks to have been chipped at some point in time, no chip now
Headlight switch. Contains panel dim, headlight, AD, AL, and fog switch- $25
Dash clock- $5
Antenna, fuel, and ride switch- $15
Trim panel for above switch - $5
Auto Dim sensor- $10 unknown condition
Window Regulators- $25 each
Large VAM- $50
A/C condenser- $25
Shifter bezel- $10 boot is junk, but there
Intercooler- $50
T5- $250 unsure on mileage, original cluster was MIA when I bought car, shifted good, no funny noises. fluid looked great.
Hydraulic bellhousing- $50
Slave cylinder- $10
Clutch master cylinder- $10
Clutch fork- $20
Short throw shifter- $50 unknown brand
Driveshaft- $35
Electric fans- $25
Square style intake manifold, upper and lower- $50
Distributor- $15
Valve cover- $20 as is, $75 if I clean up, sand, and repaint
Engine harness- $40
PRC/ABS harness- $30
8.8 with 3.55 gears complete rotor-rotor with calipers- $200
Spindles- SOLD
Front calipers-$20 each
Doors- $40 each
Front fenders- $25 each
Snowflake wheels. Have 5 total, only 4 caps though (i think, might be able to round up a 5th cap)-$25 each, $100 for set. Have never tried cleaning them up, but they should clean up
All prices are OBO plus buyer pays shipping
How about the little pull strap covers on the doors?
I'm looking for a 5 speed shifter bezel .
What color interior? Condition of the seats?
Looking for a hydraulic clutch fork. Is it a 5-spd?
Vinnie, are you looking for just the bezel or the bezel and boot?
Yes it is/was a 5 speed. Shoot me a PM with an offer on the fork
I am looking for the drivers side power window regulator W/ motor. I would also be interested in the passenger side as well. They must be in perfect working order.. Mine just failed.. Please PM me a price shipped to NJ
Thanks
edited original post with some parts and prices
pm sent
Just the bezel. If the boot is , leave it as an assembly so I can use the clips and such.
Let me know how much.
PM sent.
Vinnie, hate to say it but upon closer inspection, one of the corners is broke. If you still want it for the small pieces or whatnot, just pay for the ride and it's yours
I appreciate it, but I'll continue the search.
I have an automatic bezel out of a 83, but that probably wont do you any good.
I need the passenger side trunk hinge. From what I can tell, it's held in by a stamped pin of sorts. Is that possible you could grab that for me?
Vin, you have a PM
That's funny.........so do you. LOL.
Hook me up.
Dougy_Fresh your PM box is full!
Shoot me your best deal o0n that hinge and I'll PayPal you the funds. Thanks.
One more thing. Can you send the pin along as well that hols the hinge in place? Since you're parting the car anyway, If you could just cut off the welded bracket and send that instead of cutting the pin, that would be best. The bracket doesn't have to be perfect. Thanks again.
Vinnie, I sent you a PM. did you get it? I cut around the pin, I have the arm and pin laying on my desk
No pm showing. That's exactly what I needed. How much?
Leaving now to ship all parts that are sold. Thanks Beast50, Ramos617, and Vinnie!
Thank YOU!!!
I tried to respond to pm but your box was full. I will take the spindles, please pm the details. I hope that made sense.
hunter, I shot you another PM, if you do not get it, let me know and I will give you my phone number
Just wondering if you got the clutch fork pulled. Your PM box was full.
well, I think I sent you 2 PM's, but it doesn't show up in my sent items folder.
anyway, have you got the passenger side door moulding in good shape? I got side swiped and would like to replace it if I can get a good one.
How's the rear quarter panels on the car. Can you take some pics. Might be interested in both of the doors as well. Looking for rust free preferred, but good condition could be considered as well. Would also like pics of the snowflake rims too please. If you like either PM the pics to me or text them to me at 815-499-three eight zero four.
Thanks for the shipping quote, I will take the spindles. Shoot me another pm regarding payment info and thanks again.
Payment sent, thanks!
how are the door seals, the ones that go all the way around the door opening?
the drivers side is just a bit flattened, still usable, but kind of concave I guess you would say. Passenger side is the same, except there is a small tear at the bottom. I had never even noticed it until I went out to check them for you. There is a 1/4-3/8" gap between the ends
Thanks for checking, sorry I'll pass.
How about the air cleaner housing and big rubber elbow that connects to the VAM?
Bump
You have a PM.
few more weeks and this one will be going to the crusher. anyone needing parts please speak now
Looking for the trim behind the wheel on the passengers side.
front wheel or rear wheel?
Hi, do you have original antenna?
Rear wheel. Sorry I missed your post
How far are you from Louisville? I need a few parts like the dash, maybe fenders, and some misc stuff.
well folks, looks like I have changed my mind (and am now kinda kicking myself in the arse) but I will be keeping the rest of the car. Luckily everything I had sold is fairly easily replaced, the trunk hinge will definitely be the hardest to replace, both in finding one and putting it in.