I recently swapped to a floor shifter, all the gears line up properly. However the neutral safety switch is wrong. Reverse lights come on in park, treats reverse as neutral(and park as reverse obviously). If I don't get information by tomorrow morning 7am CST I'm going to try to figure it out on my own. I hope I don't have to resort to just using toggle switches(which I've been known to use for everything from headlights, blinkers and etc.).
Did you cut and splice the wires, or use a factory-type connector?
On mine, since I was too impatient to wait, I just spliced the wires together, to get it to start. Of course, I have no backup lights...but then again, I probably won't legally drive it on the road till the year 2597......
You have the wires reversed.
I never dropped the transmission, never disconnected any wires, I just dropped the pan. So you can see why I am stumped.
disregard...gear selector arm washiznitting pan. It has full range of motion and functions with the pan out. So I'm very delicately notching the pan.