Hey guys I'm new to the board. Just bought an 87 Tbird about a month ago and knew it would need an exhaust. its a stock 5.0 right now. I wanna go dual with it and I've been told fox body h pipe would work on it.... anyone have any thoughts or experience with this?
On my 88.
I used stock Mustang shorty headers, bolted up to a Summit Hpipe and stock 94 Cobra lers with the stock flowtube attatched. You may need a double hump crossmember, my car already had one on it. It all bolted in like it was made for it.
I dont have tailpipes on currently, It is just dumped after the lers.
same on mine, we used a jegs mustang 2.5 inch catback with dumps, came in about 8 inches too short... looked funky because it was right below the gas tank (like wheelie bars)
had a exhaust shop custom make from the axle back using my catback kit, cost me $90 or so.
example of stock mustang "GT" (dump style) catback with above setup
(http://i36.photobucket.com/albums/e4/gizthegizzygizmo/img502.jpg)
after the ler guy re-did it axle back
(http://i36.photobucket.com/albums/e4/gizthegizzygizmo/bothrims.jpg)
(http://i36.photobucket.com/albums/e4/gizthegizzygizmo/photobucket-5706-1329948536660.jpg)
I'm currently working on a long-tube headers, x-pipe side outlet install....so far after 6 hours I have one header installed lol. I also have to throw in my floor shifter...guess I'll be hitchin' a ride for work for a few days.
mac shortys, pipes x pipe no cats and flowmaster 40 series dual chambers with 2 1/2 over the axle with lx mustang tips. you need to add to them to make them reach the back of the car.
Thanks for the help guys, I appreciate it