i just had a explorer motor dropped off at the shop, will be for sale in roughly 2 weeks. she'll be fully rebuilt with decked/ported heads (GT40p's). I'm using an abundance of parts i have sitting on the shelf to put her back together including the following..
- Speed Pro .030 pistons (click me! (http://"http://www.summitracing.com/parts/TRW-L2482F30/"))
- Clevite 77 rod and main bearings
- Summit Stage 1 rods (click me! (http://"http://www.summitracing.com/parts/SME-5-44-05-200/"))
- SCAT cast ccrank (click me! (http://"http://www.summitracing.com/parts/SCA-93022/"))
- Lunati cam (THIS cam.. click me! (http://"http://www.summitracing.com/parts/LUN-51014LUN/"))
- Cloyes HD double roller timing chain/gear set
- Milodon HV oil pump
- B&M flexplate
the motor was a .030 jasper motor with approximately 120k on it.. heads and crank will go to the machine shop early next week, after i disassemble the motor. it'll either come with the OEM explorer intake and typical stang EFI distributor OR with..
- heavily ported Edelbrock RPM air gap
- HEI distributor
- MSD HEI coil
buyers choice on carb or efi, $1350 FIRM for either setup.. NO SHIPPING!! located at my new shop in cape may, nj 08204 but can meet somewhere for serious buyers within a reasonable distance
great deal for someone who wants/needs a motor, you can't build this motor for what i'm asking and it'll be fresh, including cam bearings.. i've built this similar setup for a customer in the past and he's pushing around 375hp and 410ft/lbs
What would you charge to help install it... LoL
to HELP install? no, i enjoy helping people out with their stuff.. i don't travel though LOL