Well today (saturday) I picked up front and rear swaybars, rack and pinion and hood from 88 turbocoupe for 100 bucks. I do need to do some work on the hood. it has some rust along the front 2 inches or so that ill need to sand down and repair but it shouldnt be all that bad. now to make it fit my car with a 5.0 efi lol
To make it fit you should just have to grind the alt. bracket down alittle bit.. I had to and the hood closes fine now.
My alternator bracket is fine.The a/c bracket had to be helped a little.
good ill know what to check for lol
lol just dont slam the hood shut the first time or you might have a dimple or two to fix
We put a 5.0 with a Vortech on it into my son's project TC and we didn't have to modify it at all. The hood fit just fine. Oh, I take that back, we did remove the plastic duct work. That was it though.
Having said that, follow T-BirdX3's advice anyway. Close it very carefully the first few times, just to be safe.
Where were the parts from? Any cheap set of snowflake rims or radio/center bezel?
i think the guy may have a set of snowflakes ill give him a buzz tomorrow and ask him if you would like
i have a set of snow flakes and the radio bezal if u need it
I'm local-ish to him, that's why I asked.