I am setup to do a PV Clearance check. I have a few questions.
I have made a set of check springs that fit perfectly and do not compress the Hydraulic lifter.
1. Am I supposed to install a HG when I do the check? Seems like a waste of a perfectly good HG. Not to mention all the cleaning sing involved in removing it when I am finished.
2. Can I just do the check without the gasket and add my compressed gasket thickness (0.038) to my clay reading?
3. I have 1.6 roller rockers. Will they clear the stock Valve covers? If not, is there a valve cover I can buy that will clear the rockers but let me keep the stock efi intake?
I am planning on replacing the stock intake but I have run out of cash for right now. I was hoping to not have to buy 2 spacers (one for the stock intake and one for the replacement).
Thanks!
DZ
1 & 2 : Yes. That is correct to do.
3. Stock aluminum HO covers -- yes. You will most likely have to remove the oil baffle however. The stamped steel covers will not clear.