Chuck
do you have a pattern on the 5.0 engine mounts? In a drawing that can be posted or emailed? It would be nice to have it when i make my next set. I have my own now but they are flat from the block to the mount. I know tom said there is about a 7/8 '' transition in height but like i said,, it would be nice to have the pattern.
You'd think I would have seen this a couple days ago.
PM me.
here is what i plan on doing with some decent 2x4 7/16 angle iron welded back to back.
all i was really wanting was the measurements on hole orientation or just the measurements from the rear of the block to the motor mount hole. I suppose i could go off what i have and tinker.
I have made myself a set of flat mounts identical to this with no offset.
the distance for the motor mount holes are not the same on each side. I came up with 3/4'' difference making the longer line on the driver side. I understand what you mean though.,,, thanks for the exact measurement.
You got the dimensions, but the holes are actually the same fore and aft on the mounts, the width is what is different.