Skip to main content ↑ ↓

Show Posts

This section allows you to view all Show Posts made by this member. Note that you can only see Show Posts made in areas you currently have access to.

Messages - Glenn B

1
Electrical Tech / Can anyone help me ID this?
Now that I've had a morning to troubleshoot, here is where I am.
Found the plug with the wires going to blower motor. confirmed different voltages for 3 fan speeds at power side of plug. Applies 12v and known good ground to load side of plug and fan does not run. Ohm meter confirms open. So I guess I'm going to be pulling the dash to get to the blower.

  I would like to thank all who replied. All opinions are appreciated. I have been looking around this site and forum. You people are awesome. The amount of information shared here is great. I will offer any info I can. A special thanks to all who contributed to the dash R&R procedure on this site. You make it look less intimidating. I will let you know how I make out.
3
Electrical Tech / Can anyone help me ID this?
Quote from: CoogarXR;466330
Too small of a resistor for a blower motor. Looks more like a resistor across a thermistor, AKA temperature sensor. Is this for a car with automatic/digital temperature controls?


That Is what I have. Think it's called "automatic temperature control".  Do you know if the blower would run or not, if this component is defective? I did not get any failure codes. All fuses are good.
Thanks for your help.
4
Electrical Tech / Can anyone help me ID this?
1986 Turbo Coupe. Came out of blower housing. Blower was working  before I removed this part. when reinstalled blower no longer works, one wire carries 5.3 volts when ignition on.